WenZhou TengChang Tech-trade co.,ltd
the fiber optic tools; fiber optic test equipments and other related Supplies. fiber stripper,fiber cleaver,fiber tools,cable tools,fiber optical toolkits,Fiber optical Fusion splicer,OTDR,Optical light source , power meter,fiber optic cleaners , Optical fiber identifier,Visual Fault Locator

Ilsintech EI-21 electrode fusion splicer

Electrodes For Fusion Splicer

Electrodes For  Fusion Splicer 

Fujikura ELCT2-20A


Sumitomo ER-10


Fitel S960


Fujikura 40S


Ilsintech EI-21

S3 S5 KF4 K3 K7 K11

Comway CE-03


Ilsintech EI-19

Swift-F1 Swift-F3 KF2A


 IFS-15 IFS-10 View3 View5 View7 IFS-15 V7 V3 V5

CETC41 Electrodes

CETC AV6471 AV6471A AV6471AG AV6496A


DVP-600 DVP-720A DVP-720B 730 730A 730B 750

Fitel S969 Electrodes


Fujikura ELCT2-12

Fujikura FSM-12S/FSM11R/11S /21S /12R FSM-22S

fusion splicer electrodes.png

Change electrode method:
First, must confirm the welding machine in a shutdown state, take the electrode chamber protective cover, screw loosen the fixed electrode extraction electrode; then release the electrode silk top, remove the lower electrode.
Secondly, the installation of new electrode, the operation steps and the method of removing the electrode is the opposite, in turn, can be operated. The two electrode tip clearance requirements for : 2.6 + / - 0.2 mm.
Finally, in the assembly process, not can touch the tip of the electrode and to prevent damage to the electrode, and avoid electrode fall into the machine internal damage caused by. After replacing the electrode, the arc position should be calibrated
Electrode cleaning and arc calibration:
1. In the electrode after the installation is complete, open welding machine power switch.
2. Welding machine into the initial screen, press the menu button to enter the menu.
3. Through the movement of the cursor is located the machine maintenance and cleaning electrode entry. After confirmation, machine will automatically discharge cleaning and electrode aging.
4. Installation must good left / right fiber, through the movement of the cursor to find the arc position, through the operation of the fiber end and two electrode tips to keep the three-point line position, the machine will discharge test, according to the actual situation can be adjusted.
5 Finally, press the menu key, turn out.





Contact: silvia

Phone: +86-15068232998

E-mail: silvia@fibertc-tools.com

Add: 3 F ,NO.3  JiaoDao Road .OuHai District  WenZhou ,ZheJiang, China .